home *** CD-ROM | disk | FTP | other *** search
/ ZAM 4 / ZAM 4.adf / Articles / 11 < prev    next >
Text File  |  1994-03-08  |  3KB  |  54 lines

  1.  
  2.                             Pal -> NTSC
  3.  
  4. This is a simple hack that can be performed by anyone but best left to
  5. someone with a fair knowledge of electronics.  The idea is to stretch
  6. your software to fill the botton third of the screen when using NTSC
  7. software, there is nothing worse that buying software only to see it
  8. doesn't use all of the screen.  Many a PC owning friend has asked why
  9. does it have that black spot at the bottom?
  10.  
  11. Well I wondered too! but no longer, I had noticed when using my Amiga
  12. that it sometimes boots up in NTSC, you know when the screen won't 
  13. display anything past 200 lines.  When if it can boot when it wants to,
  14. why can't it boot when I want to!
  15.  
  16. The first thing you require in order for this mod to work is a Fat Angus
  17. No 8372A, you can check this out with a program called Sysinfo. (There is
  18. a version on CU Amiga Disk 46 Dec 92).  You also need one SPDT switch and
  19. two 500mm hook up wire.  To make job secure a low wattage soldering iron.
  20.  
  21. Right, from here on in your own your own, anything you do you take full
  22. responabilty for, if you are unsure, STOP! and let your techie do the job.
  23.  
  24. REV 6 Boards
  25. ------------
  26. Opening up your Amiga 500 and exposing the motherboard you reveal the
  27. ECS Angus Chip near the main CPU 68000, looking closer you can see a
  28. jumper pads marked on the board JP4, this is between the two chips. This
  29. jumper should be in fact open as is the case with PAL Amiga's, now the
  30. idea is to connect a switch between the jumper therefore connecting it
  31. in one mode and disconnecting in the other. What in fact this does is
  32. take to earth off Pin 41 of the Angus Chip and make it boot Pal. Solder
  33. a wire to each pad and connect it to the switch that can be mounted on
  34. the outside of your machine.
  35.  
  36. REV 5 Boards                   Only works if a Angus 8372A installed
  37. ------------
  38. Opening your case you will find you do not have a jumper marked JP4, so 
  39. your mod is a little more difficult, what you must do is bend pin 41 of
  40. the Angus chip out and carefully solder one wire to the pin, the other
  41. wire is then grounded.  Install the switch as per REV 6 boards and you
  42. have NTSC mode as well.  
  43.  
  44. The switch can be thrown at any time, even if the machine is running but
  45. the effect will not take place until a warm boot, now you should find
  46. that your NTSC software will fill the screen, it does on my monitor
  47. anyway. Of course this mod can be performed on Amiga 2000's as well.
  48.  
  49. Of course there is always the easy way of using a simple program called
  50. 60Mhz or Action Replay Mk III has a Pal/NTSC mod.  I find this way more 
  51. reliable........
  52.  
  53. Happy Hacking!
  54.